Portable Infrared Heat Banks:
Portable electric IR banks allow the flexibility of moving electric infrared units in/out of a production line when additional heat is required.  These units can be used for a variety of applications but are typically used for paint and powder curing, dry-off, boost, flash-off, gel, and pre-gel applications.
The Advantages of Electric Infrared Heat:

Efficiency – focus the IR at the product and heat the coating, not the ambient air; instant on-off; no time wasted bringing emitters up to temperature.

Repeatable results – consistent performance through effective control of the amount of heat required, even if pass through or dwell times vary.  Many control options are available.

Smaller footprint – these IR banks use very little floor space, especially when compared to conventional curing ovens.
​​We offer Custom Models using Standard Equipment for quick and inexpensive oven configurations that are designed specifically for the customers’ application:
  • All sections are designed so they can be bolted together side-by-side or end-to-end; making the assembly of small, medium and large banks possible.
  • Sections are designed to accept ONE or TWO short wavelength (T-3 lamps) or medium wavelength (quartz tubes) IR emitters; at a wide range of wattages at all standard industrial voltages.  All sections/banks can be wired for single or 3 phase operation; and in series, parallel or combinations to suit the process and controls requirements.
  • Sections are mounted to a heavy-duty steel stand with durable and lockable casters for ease of mobility and stability.  Stands can be adjusted to accommodate various width heat sections.
  • All portable banks are supplied with a circuit breaker disconnect, rated per code for the amperage of the heat load; and include an ON/OFF switch with lockable handle.​ 
  • Optional blowers can be integrated into the heat sections to add air to the finishing or dry-off process; and to wick away moisture during the cure of water-based coatings.
  • ​Adjustable straps are used to tilt the heat sections, when required, to precisely focus the infrared energy.
Automotive Application:

An example of the banks heating automotive body parts.  This equipment was designed with a control panel mounted to the frame.  The system had the capability of heating a product to an exact temperature and subsequently holding it for a time period to allow for proper curing.

The panel is equipped with the following components: 
  • SCR Controls
  • Temperature Controller
  • Radiometer Sensor
  • Manual Power Controls
All portable ovens can be equipped with high tech control panel systems if required by the customer’s process